First, not sure if this question belongs here or SU, so please advice accordingly before wildly down-voting or blasting me. We have a UPS unit for which we recently configured to work on our network. The UPS unit uses an AP9606 network card, but also has what looks to be a serial port for terminal use (putty is awesome). I am NOT familiar with the latter. Long story short, I was able to configure network adapter using telnet. APC 15ft Serial Cable to RJ12 940. Marine hydronic heating system design. FTDI USB to SERIAL / RS232 Console Rollover Cable For Cisco Routers - RJ45. UPS devices pinouts. APC RJ12 serial cable RJ12 to DB9. APC Smart UPS DB9 to Intel server MB RJ45 serial A connector For Intel server UPS. Adobe flash pro cs6 crack amtlib dll fixer. Not just cracks, but trainings, freebies, templates etc. We also run other sites and facebook pages where we provide tons of resources for graphic and web designers. All was good. For whatever reason, when we reboot our machine that we had configured for auto-shutdown with our UPS unit, the NIC on the UPS seemingly just dropped it's IP configuration (still trying to figure that one out). Ever since, any attempt trying to make contact with the NIC fails. Steps attempted thus far: • I did manual arp entry to reach out to as per. • Hit the reset button, and the reattempted the previous step. APC BackUPS Es• Ran WireShark while attempting previous steps to see if the NIC's MAC or IP appeared anywhere for ARP requests. The only thing that seperates me from the UPS unit is 48p switch, so there shouldn't be any network filtering within the same subnet. I don't have any way of telling if the card is just wnt bad, or if I really have to attempt the serial as. Because we inhereted the UPS unit, this smart-signalling cable is nowhere to be found. Tripp-lite OmniPro 675 UPSHowever, I have here in hand a Cisco YC Cable that looks like it could work, but I am having hard time trying to find the wire configuration to see if they would match up. OTOH, getting this APC cable would also mean I would have to find an antiquated computer that also has a serial port. Having configured a number of SmartUPSes with AP9606 in my time, I do not remember ever having had the need for an 'APC-proprietary' serial cable. ![]() ![]() The looks like a simple null-modem cable swapping the TX and RX pins: +-----------------------------------------------------------------+||| Black APC 940-0024C Smart Signalling UPS Cable Wiring Diagram|| This information is verified and tested to be 100% correct.||| +-----------------------------------------------------------------+||| DB9M(UPS) 2m Cable DB9F(Computer)|| --------- -------- --------------|||| (SHELL). Well, it may be proprietary (in the sense of it being a non standard pinout), but you can find pinout diagrams if you know what you are looking for, and if you have a few inexpensive tools, you can also make one. Here's a fairly simple one: This is the 0024C model: +-----------------------------------------------------------------+||| Black APC 940-0024C Smart Signalling UPS Cable Wiring Diagram|| This information is verified and tested to be 100% correct.||| +-----------------------------------------------------------------+||| DB9M(UPS) 2m Cable DB9F(Computer)|| --------- -------- --------------|||| (SHELL). If the cable wiring diagram given at is accurate, then it's basically just pins 2,3, and ground.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |